TechNote TI ML-07
microLaser/microWriter series - SORRY, TI MICROxxxx CANNOT BE USED

  ·Legacy·
Technical support has been discontinued for all listed models.

SUMMARY: When Chooser is selected, a dialog box opens with the error SORRY, TI MICROxxxx CANNOT BE USED (where xxxx is LASER or WRITER).

CAUSE: The Paper Tray Manager (PTM) drivers developed for System 6 are installed in a higher version of MacOS.

SOLUTION: Remove PTM and re-install LaserWriter and the appropriate PPD files:

Delete the files associated with PTM for the microLaser, microLaser Plus, and microLaser XL:

Extensions folder

Control Panel folder

Delete the files associated with PTM for the microWriter:

Extensions folder

Control Panel Folder

Re-install LaserWriter.

Install the PPD driver files for the appropriate model.
Copyright © 2000 GENICOM,

Specifications subject to change without notice.
® All trademarks are property of their respective holders at the time of this publication.


If you have any questions or comments regarding this document, please contact TallyGenicom Technical Support.
TallyGenicom has taken care to ensure that the information is complete, accurate and up-to-date. However, GENICOM assumes no responsibility for errors or omissions which may occur. All the information provided is subject to change from time to time at the sole discretion of GENICOM. This information is provided "as is" without warranty of any kind. GENICOM disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall GENICOM, or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if GENICOM, or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion or limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.